Home / all news & press /

The Tips For Using Air Stapler

date
2023/08/01

The Tips For Using Air Stapler

Operating

Place the stapler gun against the work surface so that the nose-piece of the too is where you want the staple to be located.

Push the tool firmly down on the work surface.

Squeeze the trigger to fire a stapler.

To fire the staple gun simply squeeze the triggerNever operate too unless safety nose is contact with workplace.Do not operate tool without fasteners or damage to tool may result.

Never fire fasteners into air because fasteners may injury operator or others and damage to tool may result.

Maintenance required

Description

Tools or materials required

Maximum service interval

Each use or every 2 hrs

Monthly

As needed

General inspection-free movement

Trigger, spring, safety mechanism

None



In-depth inspection

Worn or broken parts



Replace worn or broken parts





Lubrication

See below

Pneumatic tool oil



WARNING:It any of the following symptoms appears during your operationstop using the too immediately,or serious personal injury could result.Only a qualified persons or an authorized service center can perform repairs or replacement of toolDisconnect tool from air supply before attempting repair or adjustment.When replacing O-rings or cylinder,lubricate with air tool oil before assembly.

Problem

Check

SOLUTIONS

stapler operates but no nail is driven.

Check for jam.

Check feeder function.

Check for proper nails.

Clear a nail jam.

Clean and lubricate

Use correct nails.

Week drive.Slow to cycle

Check air pressure

Drive blade worn?

Piston O-ring worn or damaged

Increase air pressure.Do not exceed 120 psi.Use pneumatic oil.

Purchase Drive Pin or Seal

Purchase Drive Pin or Seal

1. Check air pressure

1.Reduce air pressure 60-100 psi.

Skipping nails,Intermittent feed.

Check for proper nails.

Check nail feeder function

Piston O-ring cut or worn out

Check for proper nails

Use only recommended nails.

Clean and lubricate and use pneumatic oil.

Purchase Seal.

Use only recommended nails.

Nails jam, Driven nail is bent

1.Drive blade worn.

1.Purchase Drive Pin.

Drives properly at normal speed but does not drive fully drive at faster nailing speed

1.Check inside hose diameter.

1.Use larger air hose.

Tooll jams.

Incorrect or damaged fasteners.

Damaged or worn driver guide.

Change and use correct fastener.

Check and replace the driver.

 

Let's see the AEROPRO A8016:

Strong and light weight aluminum die-casting gun body
Special hardened one piece dirve blade for professional application
Teflon O-ring protect the piston from wearing

Model

A8016

Dimension

220.5*140.5*43.2mm

Weight

1kg

Required pressure

70-110PSI(5.5-7.5bar)

Max.pressure

120PSI(8.3bar)

Nail Capacity

125pcs

1